Adding Split Lines To Create An Isolated Area of Sloping Floor  

New Member Member

When I come to add the split lines to a floor so that I can make the shower room floor slope down to the drainage hole, is there some way I can pick lines along the faces of the walls facing the shower room? It doesn't seem to allow this, which means I have to set out with reference planes or lines before I can trace over with the split lines.

Posted : 21/05/2018 7:26 pm
Honorable Member Admin

Your method is about as good as it gets. There is no "Pick Lines" tool when you are adding the Split Lines.

Many thanks,

Kind regards,


Posted : 25/06/2018 10:38 pm