i have created a structural conc. column. then i have used model in place to create a circular void extrusion through the column. when i try to use the cut geometry command to cut the void from the column, it'll only allow me to pick the void but not the column. your help would be greatly appreciated.
Posted : 16/04/2018 10:16 pm
Ian liked
It is not going to cut a void through it, as the column is a component family. That workflow is (typically) used with System Families- ie cutting voids in Floors, Walls, Roof, etc- ie System Families.
Can you add the void form directly to the Family itself?
Kind regards,
Ian
Posted : 19/04/2018 10:44 pm
Thanks for your reply. I need to learn about families first before I could do this.
Posted : 21/04/2018 8:05 am
Ian liked
Thanks for your reply. I need to learn about families first before I could do this.
I really need to understand why you need that void in the column. It may be better to include a void in the family itself rahter than trying to cut one through it in the project?
Many thanks,
Kind regards,
Ian
Posted : 28/04/2018 11:38 am